How to Reverse the Display
CubeX Reverse Display Quick Guide
The LED display on the CubeX can be reversed to be readable in either direction. There are two ways to do this, one which is temporary and one which will remain until reversed again.
To temporarily reverse the display, just press the display reverse button on the control panel while the CubeX is on. The display will flip each time the button is pressed and will go back to how it was before when you restart the CubeX.
To reverse the display on a CubeX and keep it that way, hold down the 1, 2, and 3 buttons at the same time while turning the unit on. The new display setting will be saved even after restarting and can be changed back using the same method.
If you need to reverse the actual display sticker because you are mounting the CubeX on a table or stand, or removing it from one, contact JPI about purchasing a replacement display sticker
Related Articles
Service Guides
Service GuidesManual for CUBE X series (for veterinary use only)_210429 (1)
Manual for CUBE series (for veterinary use only)_210429 (1)Service Manual
Service ManualSpecs Sheets
Specs SheetsVeterinary Technique Charts
Companion Animal Technique Chart ANATOMY POSITION Small Medium Large X large KVP mAs KVP mAs KVP mAs KVP mAs CHEST AP/PA 50 1 66 2 80 2 95 3 LAT. 55 2 70 3 96 3 110 4 CLAVICLE 50 1 65 2 80 2 83 3 RIP-AP 50 1 70 2 85 2 100 3 RIP-OBL. 52 2 74 2 88 3 ...